Copper Head Gasket

Copper Head GasketWartime GPW Head exchange!

Finally, after so many delays it just got to be silly, the Jeep is back up and driving again! In this extra-long update, I go through the entire process of changing out my CJ2 engine head to a wartime GPW head! That includes adding the correct studs, bolts, a GPW thermostat, and a copper gasket. It’s been a multi-week project! I also continue replacing bolts with correct recessed head bolts and replace one of the top bow brackets with a GPW one. Plus several other things!

Continue reading “Wartime GPW Head exchange!”

GPW Engine Head

GPW Engine HeadBirthday Present for the Jeep!

This week I had a few small projects, and started one big project! Since the Jeep turned 76 last week, I got ahold of an original GPW head block which I’ll be putting on the engine with the correct studs/F Bolts! This week includes PART 1 of installation! I also continued work on adding recessed head bolts, attempted to make inspector stamps for the Voltage Regulator, and more. It’s a bit of a smaller update than usual, but still some good work!

Continue reading “Birthday Present for the Jeep!”

L134 Engine Block without Head

L134 Engine Block without HeadMajor work done this week!

In a quest to stop the coolant leaks, I took apart the engine head to replace a gasket, quite the ordeal! Plus, restoration work was finished on the replacement Jerry Can, and the accelerator linkage was adjusted. Felt like back a few months ago during the heart of the restoration with all the work!

Continue reading “Major work done this week!”

Carter WO CarburetorEngine problems!

The restoration has slowed to a crawl as I finish the last little bits. Compared to just a few weeks ago, it seems like not much is getting done. But a major engine issue has plagued me this entire week causing me to stop everything and work on various tests. It’s been frustrating to say the least…

Continue reading “Engine problems!”

MD Juan Body Tub compared with the original GPW Tub

MD Juan Body Tub compared with the original GPW TubBody Tub ALMOST done!

Another busy week working on the Jeep every morning and evening (plus weekends). Not quite as fast of a pace as I was hoping, but still getting lots of progress. Going back and forth between working on the engine, painting various things, and drilling holes in the new body tub..

Continue reading “Body Tub ALMOST done!”

MD Juan Body Tub Hole Drilling

MD Juan Body Tub Hole DrillingLast update for 2 weeks!

Got some things done on the new repro tub such as sanding and drilling holes, but it’s been quite the pain! A new shipment of items arrived, like a new muffler and special filter system for the air bath. I’m taking a break for two weeks for a vacation, so updates will continue once I start back up! Then it’s in super drive mode for the home stretch to finish it by mid-july!

Continue reading “Last update for 2 weeks!”